Table of Contents
Advertisement
SE485 Interface
Introduction
The SE485 is designed as an interface between the RS-485 signal bus of the Security Escort Transponder, and
the Serial Bus (RS-232) of the Security Escort Central Station.
Specifications
Dimensions:
Power:
Recommended Cable:
Compatibility:
Installation
•
Remove the cover by removing the cover screws shown below.
•
Connect the wiring as shown below.
•
After wiring the system, replace the cover and power up the unit.
Installation and Operation Notes
•
Each Transponder must have its own address.
•
For the Security Escort
adaptor provided plugged into an uninterrupted power supply (UPS).
•
The SE485 may also be powered from the Transponder's 9 V output connected to the 9 VDC input wiring
connectors.
•
Up to four SE485s can be included in an installation. If using multiple SE485s, use the connector cable provided.
135 mm (5.375 in.) x 85 mm (3.031 in.) x 30 mm (1.187 in.)
Use the included 120 VAC adaptor to 9 VDC, 300 mA or power from the Transponder
2 twisted pair,
4 conductor, 22 AWG (0.8 mm)
EA500B Transponder
EA501B Transponder
System to maintain operation, the SE485 must be powered at all times. Use the 9 V
®
Security Escort Training
Page 39 of 142
Advertisement
Table of Contents
