Table of Contents
Advertisement
"System Serial Port 2"
This option selects the events that will be sent to the System Serial Port 2. System Serial Port 2 is assigned a
physical Comm Port in the "Remote Comm Port Setup" dialog and its function must be set to "History Filter
Output" in the "Remote Setup" dialog.
"Transponder Restriction"
This option selects a transponder for the restrictions below.
"No Restriction"
This selection typically would be left at this setting at all times. Therefore the output would not be restricted by an
individual transponder.
"Only From Transponder Selected"
The selected events would only be output if they were reported from the transponder selected in the
"Transponder Restriction" above.
"All from Transponder Selected"
All events will be reported from the transponder selected in the "Transponder Restriction" above. In addition the
selected events will be reported from all other transponders in the system.
"Alarms"
Output the information about an alarm including location, but not the transponder and receiver levels. This is the
data typically sent to a printer.
"Points, Reporting Alarm"
Output the transponder and receiver levels for an alarm. This is the data is typically too detailed to send to a
printer and is used for diagnostics, not normal system operation.
"Tests, Single Line"
Output the simple information about a test. This is the data typically sent to a printer.
"Tests Including Point Info"
Output the transponder and receiver levels for a test. This is the data is typically too detailed to send to a printer
and is used for diagnostics, not normal system operation. If this option is selected then "Test, Single Line" above
typically would not also be selected for the same output device.
"Transmitter Low Battery"
Output low battery reports received from transmitters.
"Operator Activity Log"
Output all other operator activity (audit trail) not covered by specific event selections.
"Preferences Changes"
Output all changes made to system preference selections.
"Database Backup and Restore"
Record all database backup and restore activity.
"Operator Database Changes"
Record all changes to the operator database.
Security Escort Training
Page 115 of 142
Advertisement
Table of Contents
