Table of Contents
Advertisement
About Menu
Demo Manual Alarm, Subscriber 1
For demonstration only, can't be used in
a live system, causes system to display
an alarm from the subscriber with
transmitter ID number 1. In the System
Preferences dialog check "Enable Demo
Selections" to enable these demo alarm
and trouble selections. The transponder
communication ports and network
communication ports must also be
disabled and the operator of the system
must login at Installer or Installer Master
authority level.
Demo Lanyard Alarm,
Subscriber 2
Demo Man Down Alarm,
Subscriber 3
Demo Man Down Restoral,
Subscriber 3
Demo Test Subscriber 1
Demo Test Subscriber 2
Demo Test Subscriber 3 with
low battery
Demo Troubles
Demo Trouble Restoral
Demo Maintenance Alarm
Demo Maintenance Test
For demonstration only, can't be used in a live system, causes system to
display a lanyard alarm from the subscriber with transmitter ID number 2.
For demonstration only, can't be used in a live system, causes system to
display a man down alarm from the subscriber with transmitter ID number 3.
The man down alarm is delayed by the programmed man down delay
(usually 10 seconds).
For demonstration only, can't be used in a live system, will restore a
previous man down alarm from the subscriber with transmitter ID number 2,
if it has not timed out and is not being displayed.
For demonstration only, can't be used in a live system, simulate a test from
the subscriber with transmitter ID number 1.
For demonstration only, can't be used in a live system, simulate a test from
the subscriber with transmitter ID number 2.
For demonstration only, can't be used in a live system, simulate a test from
the subscriber with transmitter ID number 3. This test will also report low
battery.
For demonstration only, can't be used in a live system, simulate troubles
from a transponder. Point troubles are simulated for AC loss, tamper and no
response. Transponder troubles are simulated for remote key and remote
key tamper. The individual troubles can be enabled or disabled in the Popup
Trouble Filter dialog. The trouble delay in the Popup Trouble Filter dialog will
also affect these troubles, therefore for demo purposes it should be set to
zero.
For demonstration only, can't be used in a live system, simulate trouble
restorals for all the troubles sent in "Demo Troubles".
For demonstration only, can't be used in a live system, simulate an alarm
from a maintenance transmitter.
For demonstration only, can't be used in a live system, simulate a test from
a maintenance transmitter.
Security Escort Training
Page 137 of 142
About Menu
Advertisement
Table of Contents
