Table of Contents
Advertisement
"Slave Computer Answers"
Allows the slave computer to answer a remote access after the programmed number of rings. If the slave does
not answer, the master will answer after the programmed number of rings plus two. Generally it is better to have
the master computer answer remote access calls.
"Direct Connect Port"
The modem port is not connected to a modem. This setting will allow a direct connection to another computer.
This additional computer will not display alarms, but otherwise will behave like a slave computer.
"Answering Machine Override"
If checked an answering machine is connected to this phone line. If the answering machine answers a remote
access call, hang up and redial. When another call is received within one minute of the last ring of a previous
call, then the Security Escort System will answer on the first ring, overriding the answering machine.
"Pulse Dial"
If checked use pulse dial on all outgoing calls. Otherwise tone dialing (default) is used.
"Answer On Ring"
Program the number of rings to answer on. If there is an answering machine on this phone line, set the number
of rings to at least 2 greater than the number of rings that the answering machine answers on. Also check the
Answering Machine Override checkbox below.
"Dialing Prefix"
On outgoing calls enter the dialing prefix, if any.
"Password"
This is the password that will be used to gain remote access to the Security Escort System. If the first 5
characters of the password match the remote systems password, read only access will be allowed. If the first 8
characters match you will be allowed to edit databases remotely (not currently implemented). If all 12 characters
match then you will also be allowed to change system parameters remotely.
"Password Verify"
For verification reenter the same password from above.
"Disabled"
If selected, this system serial port is disabled (default).
"History Filter Output"
If selected, this system serial port will send out whatever items are selected in the "History Filter" dialog.
"Video Switcher Control"
If selected, this system serial port will send out the strings programmed in the "Video Switcher" field of the
"Transponder Database Edit" dialog's Area data. Also see Video Switcher Restore below.
"Remote System Control"
If selected, this system will be controlled by another system through a proprietarily protocol. This setting can only
be used when two systems are specifically designed to work together.
Security Escort Training
Page 51 of 142
Advertisement
Table of Contents
