Table of Contents
Advertisement
Receiver Configuration
Once the Receiver and Alert Unit data for a Transponder has been entered into the Transponder Database, this
dialog is used to verify that each Receiver is working and is properly addressed in the database. This setup tool
identifies errors in the address switch settings of Receivers and Alert Units as well as data entry errors in the
Transponder Database.
"Put This Receiver In Setup Mode"
This button initiates the "Setup" process by causing both the Red and Green LED's of the selected Receiver to
go on. The red and green LED will be flashing. On the Console, the dialog will change to present an "Abort
setup for this MUX Point" button to allow proceeding to the next device in the event that one Receiver is not set
up properly.
"Automatic Advance"
If this box is checked, the Central Console will automatically select the Receiver with the next higher "Point"
address.
"Horn - Siren"
If this checkbox is checked the horn output of a receiver or the siren output of an alert unit will be turned on if
"On" is clicked or off if "Off" is clicked. If this checkbox is not checked, then the state of this output will not
change.
"Green LED"
If this checkbox is checked the green LED output of a receiver or the spare output of an alert unit will be turned
on if "On" is clicked or off if "Off" is clicked. If this checkbox is not checked, then the state of this output will not
change.
"Red LED - Strobe"
If this checkbox is checked the red LED output of a receiver or the strobe output of an alert unit will be turned on
if "On" is clicked or off if "Off" is clicked. If this checkbox is not checked, then the state of this output will not
change.
Receiver Configuration Dialog
Security Escort Training
Page 123 of 142
Advertisement
Table of Contents
