Telephone Numbers; List Options; Clock Programming; Getting Started Back To Base - Bosch Solution 16plus Quick Start Manual

[MENU] to exit without saving.
The following additional special characters are
i
available by scrolling using the up and down arrow
Note
keys. + - @ # $ " & % * : ( ) / < > =
Te l e p hon e N u m b ers
To program, select primary telephone number under
[MENU] 5-1-1 then enter the digits of the telephone number
and press the [OK] key to save. Use the up and down arrow
keys to program special characters (, # and Pause).
PRIMARY DEST 1
0297417000

PRESS

Figure 17: Telephone Number Programming Display

Key Characters Assigned To Each Numeric Key
0 to 9 Enter the Digits 0 to 9
Scroll Up through entire character list 0 - 9 • #
 
, comma = 2 second pause
 
Move to left or right one character position
OFF Clear from cursor postiion to end of line

Table 9: Phone Number Character Set

To save programming changes, press [OK], else press
[MENU] to exit without saving.
L i s t Opt ion s
Use the [] and [] keys to step through the available
options. Press [OK] to save or [MENU] to exit without
saving.
You can also enter the option number directly
i
followed by [OK].
Note
ZONE TYPE ZN001
01 - Burglary Delay 1
PRESS 

Figure 18: List Option Programming Display

C lo c k Program m in g
Use the left and right arrow keys to move to the field then
use the up and down arrow keys to change. Press [OK] to
save or [MENU] to exit without saving.
Scroll through hours to change from am to pm.
i
Note
SET DATE AND TIME
01-Jan-2005 12:00 am
i
PRESS 

Figure 19: Clock Programming Display

Bosch Security Systems 09/06 BLCC100R
P001
0-9 OK to SAVE
0-9 OK to SAVE
OK to SAVE
G et ting Sta r ted Ba ck To B a s e
The following steps are the mimimum requirements to get
the system reporting back to base. Examples assume the
panel is disarmed with no alarms and starting from factory
default settings.
1) Enter Program mode.
[1234 + MENU]
2) Set Time and Date.
[MENU 7-1-0]
3) Change Default Installer PIN.
[MENU 1-5-2]
4) Change Default Master Code PIN.
[MENU 1-1-1]
5) Enter Account (client) Number, Area 1.
[MENU 2-2-0]
6) Enter Base Primary Telephone Number.
[MENU 5-1-1]
7) Enter Base Secondary Telephone Number.
[MENU 5-1-2]
8) Hold Down MENU To Exit.
S e r v ice M od e
Service mode when activated disables dialler reporting,
prevents all alarms and prevents all users from arming the
system.
To Turn Service Mode ON
1) Enter Program Mode.
[1234 + MENU]
2) Turn Service Mode On.
[MENU 7-0-8]
3) Follow Display Prompts.
4) Hold down MENU to exit.
Keypads will display the word Service when service
i
mode is active.
Note
To Turn Service Mode OFF
1) Enter Program Mode.
[1234 + MENU]
2) Turn Service Mode On.
[MENU 7-0-8]
3) Follow Display Prompts.
4) Hold down MENU To Exit.
Keypads will display the word Service when service
i
mode is active.
Note
D efa ul tin g The System
Defaulting the system will reset all programming options
back to the factory default setting. All programming
information will be erased.
Solution 16 Quick Start Guide
plus
13