Wiring
Wire the Alert Unit using the figure below:
Tamper Switch wired to
[T] and [P-] Terminals.
Set the Address
Every module on each multiplex bus of the Transponder must have its own address. Set the address on the Alert
Unit using the Address Switch.
Use only address numbers 0 through 7. Do NOT use address numbers 8 and 9.
Microprocessor
Battery
Connector
(Use cable)
B-
B+
SP1 T
P- P+ SI- ST-
Security Escort Training
0
Address Switch
5
_
+
AC AC
BUS-
+PWR
To Next Device
Page 38 of 142
BUS -
BUS +
Transponder
PWR -
PWR +