Table of Contents
Advertisement
Require Alarm Report
Security Alarms Silent
Installer Alarms Silent
Alarm Voice Output
Show Personal Data
No Receiver Icons
Show Tests On The Map
All Pager Confm Not Reqd
Option 4
Option 5
Auto Silence Alarm In 'X'
Seconds
Recall Operator In 'X' Seconds
On Outside Tests Flash Strobe
For 'X' Seconds
If this checkbox is checked then the operator will be prompted to complete
an alarm report when the alarm is reset from the screen. If the responding
officer is required to complete the report, or if no system report is desired,
this box should not be checked. If the operator should complete the report
then check this box.
If this checkbox is checked then alarms transmitted by "Security" or
"Watchman" Transmitters are to be "silent", alerting the operator at the
Central Console, but not sounding the sirens of the Alert Units or the
Horns in the Receivers.
If this checkbox is checked then alarms transmitted by transmitters issued
to installing company representatives and visitors are to be "silent",
alerting the operator at the Central Console, but not sounding the sirens of
the Alert Units or the Horns in the Receivers. Typically this checkbox
would be checked.
If this checkbox is checked then predefined sound (.WAV) files can be
played at the alarm console for specific alarm types. Typically this
checkbox would not be checked.
If this checkbox is checked then personal height, build, hair and eye color
data will be displayed on the alarm screen.
If this checkbox is checked then individual receiver icons will not be
shown on the alarm map display. Typically this checkbox would be
checked.
If this checkbox is checked then "Tests" from subscriber's Transmitter will
be displayed on the normal map screen as "OK" or "FAIL" icons, signifying
a successful test by a valid subscriber or an attempted test transmission
from a Transmitter not in the Subscriber Database. This option doesn't
affect the display the subscriber receives from a receiver or Alert Unit's
strobe. Typically this checkbox would be checked.
If this checkbox is checked then the confirmation pager message is not
sent to the any of the pagers when the alarm is acknowledged by an
acknowledgement transmitter.
This checkbox is for a future option and at this time it has no function.
Leave this checkbox unchecked.
This checkbox is for a future option and at this time it has no function.
Leave this checkbox unchecked.
This box determines the length of time that the sirens and Horns will
sound before being automatically silenced by the Central Console. When
the sounders are automatically silenced in this way, the Central Console
remains in its "Alarm" mode. The numerical value is in seconds, and it
can be set between 0 and 9999. Typically this value would be set to
prevent violating local noise ordinances and it defaults to 240 seconds (4
minutes).
This box determines the length of time before a "Recall" alert is issued to
the operator at the Central Console when an alarm is being displayed. If
neither the mouse nor any key has been actuated for the specified length
of time, the Console will resound the "Alarm" sound once. This feature
prevents inadvertently ignoring an active alarm event. The numerical
value is in seconds, and it can be set between 0 and 240. Typically this
would be set to 60 seconds.
The entry in this box controls the approximate length of time the strobe on
an Alert Unit will flash to signify a successful Transmitter test. The value
is in seconds, and can be set between 0 and 15. Typically it is set to 5
seconds.
Security Escort Training
Page 81 of 142
Advertisement
Table of Contents
