Table of Contents
Advertisement
"COM"
The actual physical Comm port over which communications to the transponder will be carried.
"Carrier Det"
If checked, verify that the communications port is not in use before communicating. Only to be used on half
duplex links where carrier detect indicates that the link is in use. This setting is rarely used.
"No CTS "
If checked, do not monitor the Clear to Send before communicating. This setting is normally checked.
"Mon Power"
If checked, monitor the Ring Indicator pin to indicate a remote power supply used on this Comm link has not
failed. This setting is normally unchecked.
Remote Port Setup Dialog
This dialog connects the network, modem and system serial ports to the physical Comm ports on the computer
and sets their baud rate.
"Network Port"
This is the port that connects the master and slave computers of the Security Escort System. If this system has
only a single computer, this setting should be set to none.
Remote Port Setup Dialog
Security Escort Training
Page 48 of 142
Advertisement
Table of Contents
