Table of Contents
Advertisement
"Incoming Retried Messages"
This value is number of successful receptions that indicated that they retried by the sending application. If
displayed in yellow this value is more than 5% of the Successful Incoming Messages.
"Total Outgoing Messages"
This value is total number of outgoing messages sent on this port.
"Outgoing Retried Messages"
This value is number of outgoing messages that had to be retried because the receiving application did not
acknowledge them. If displayed in yellow this value is more than 5% of the Total Outgoing Messages.
"Receiver Buffer Max"
This value is maximum number of bytes that were received on this serial port, but not yet processed by the
system. If displayed in yellow more than 50% of the queue was in use.
"Transmit Buffer Max"
This value is maximum number of bytes that were processed by the system, but not yet transmitted on this serial
port. If displayed in yellow more than 50% of the queue was in use.
"Buffer Overflow"
This is the number of times that a byte was lost by the software for a serial port because the input buffer
overflowed. Bytes were being placed into the input buffer faster than the system could process them.
"Hardware Overrun"
This is the number of times that a byte was lost by the hardware for a serial port because it was not fast enough
to process the byte into the input buffer.
"Total Remote Access Connections"
This value is the total number of times that a remote access connection was successful.
"Total Wrong Access Code Attempts"
This value is the number of times that a remote access connection was attempted and rejected because a valid
remote access code was not received.
"Last Remote Access Time"
This is the time and date of the last successful remote access attempt.
"Successful Pager Messages"
This value is the number of successful pager messages that have been sent.
"Failed Pager Attempts"
This value is the number of times a pager message dial-out was unsuccessful.
"Reset Status"
Pressing this button will reset all values in this shown in this dialog.
"Refresh Data"
Pressing this button will refresh all values in this shown in this dialog. The values are not automatically updated
when the dialog is left open.
Security Escort Training
Page 127 of 142
Advertisement
Table of Contents
