Table of Contents
Advertisement
Installation
Factory Reset
The DVR has a Factory Reset switch to the left of the USB port on the rear panel. This
switch will only be used on the rare occasions that you want to return all the settings to
the original factory settings.
Caution
To reset the unit, you will need a straightened paperclip:
1.
2.
3.
4.
5.
Rev 1.00
Figure 2-16
When using the Factory Reset, you will lose any settings you have
saved. If you want to use the same DVR name registered on the
DVRNS server after initializing the system using the factory reset,
you need to contact the DVRNS server manager. Please record
and save the help desk information before factory reset.
Turn the DVR off.
Turn it on again.
While the DVR is initializing, the front panel LEDs will blink. When any of the
Camera 1 to 8 LEDs blink, poke the straightened paperclip in the unlabeled hole
to the left of the USB port.
Hold the switch until all the LEDs on the front panel are lit.
Note
When the DVR successfully resets to factory defaults all the LEDs
on the front panel flash five times.
Release the reset switch. All of the DVR's settings are now at the original settings it
had when it left the factory.
Factory Reset Switch
14
Document 900.0856
12/06
Advertisement
Table of Contents
