Table 5-14 Profiler Hold Procedure; Table 5-15 Profiler Reset Procedure - Honeywell VRX180 User Manual

How to hold a profiler
Step
1 Perform steps 1 and 2 from Start procedure
(Table 5-13).
2 Press Decrement button to move cursor to
Hold. Press Enter.
ATTENTION
A profile can also be put on HOLD by pressing the F2 button, but only if that profile's HOLD parameter was
configured as SY1 F2. See Section 5.4.
How to reset a profiler
Step
1 Place profiler in Hold.
1 Perform steps 1 and 2 from Start procedure
(Table 5-13).
2 Press Decrement button to move cursor to
Reset. Press Enter.
ATTENTION
A profile can also be RESET by pressing the F3 button, but only if that profile's RESET/RUN parameter was
configured as SY1 F3. See Section 5.4.

Table 5-14 Profiler Hold Procedure

Action

Table 5-15 Profiler Reset Procedure

Action
Video Recorder – User Manual
Result/Notes
Profile menu is displayed.
The profiler is held at its present value and the
segment's events are frozen. Elapsed time
continues. Run time stops. Events are held at
their current states.
Result/Notes
See Profiler Hold procedure inTable 5-14.
Profile menu is displayed.
Profiler is reset to segment #1. All profiler timers
are reset. All events go OFF. Profiler output
goes to starting value of segment #1.
Setpoint Profiler
203