Connecting To The Network Port; Connecting To The Rs-232C Port; Factory Reset; Figure 2-10 Network Connector - Honeywell HRSD4 User Manual

Installation

Connecting to the Network Port

The DVR can be networked using the 10/100Mb Ethernet connector. Connect a Cat5
cable with an RJ-45 jack to the DVR connector. The DVR can be networked with a
computer for remote monitoring, searching, configuration and software upgrades. See
Chapter 3, Configuration
Caution

Connecting to the RS-232C Port

An RS232 port is provided to connect an external modem for remote monitoring,
configuration, and software upgrades, and to connect a remote control keyboard. Use
a modem cable with a DB-9S (female) connector to connect to the DVR. See
Configuration

Factory Reset

The DVR has a Factory Reset switch to the right of the RS-232C connector. Use this
switch only on the rare occasions that you want to return all the settings to the original
factory settings.
28
for configuring the Ethernet connections.
Figure 2-10 Network Connector
This Network Port is not designed to be connected with cables or
wires that are intended for outdoor use.
for configuring the modem.
Figure 2-11 RS-232C Connector
Note The DVR is not supplied with a modem cable, and many
modems are not supplied with cables. Ensure that you have the
correct cable when purchasing the modem.
Chapter 3,