Table of Contents
Advertisement
Configuration
Highlight the box beside Port and press
using the Up and Down arrow buttons to increase or decrease the numbers.
Highlight Use NAT and press
Highlight the box beside DVR Name and press
allowing you to enter the DVR name to be registered on the DVRNS server.
Highlight the Check box and press
can be used.
Highlighting Save and pressing
DVRNS settings will display the help desk information of the DVRNS server in the box
beside Help Desk.
Caution
Rev 1.00
Note
You can use the domain name instead of IP address if you
already set up the DNS Server when setting up the LAN.
Note
When using the NAT (Network Address Translation) device, refer
to the NAT manufacturer's instructions for the proper network
settings.
Note
The DVR name you entered should be checked by selecting
Check, otherwise the DVRNS changes will not be saved.
Note
When entering no name or a name already registered on the
DVRNS server, an error message displays.
If you want to use the same DVR name registered on the DVRNS
server after initializing the system using the factory reset, you
need to contact the DVRNS server manager. Please record and
save the help desk information before factory reset.
. Set the port number of the DVRNS server
to toggle between On and Off.
. A virtual keyboard appears
to check whether or not the name you entered
registers the DVR on the DVRNS server. Proper
42
Document 900.0856
12/06
Advertisement
Table of Contents
