Table of Contents
Advertisement
Configuration
When the DVR is in the Event Record mode it is possible to have it record images before
the event occurs. The Pre-Event screen allows you to define how to handle pre-event
recording.
You can turn individual cameras On or Off for pre-event recording. The image speed
can be set from 0.10 to 30.00 ips (25.00 ips PAL), and image quality can be selectable
from Very High, High, Standard and Low.
You can set the amount of time to record prior to the event by adjusting the Dwell. You
can set the Dwell from 5 seconds to 30 minutes. The longer the dwell set, the fewer
maximum ips can be set.
You can save your changes by highlighting Save and pressing
exits the screen without saving the changes.
Archive Screen
Highlight Archive in the Record menu and press
appears.
Rev 1.00
Figure 3-52
Pre-Event Setup Screen
Note
When the DVR is in the Time or Time & Event mode, it ignores
the pre-event settings and follows the time settings.
, and the Archive setup screen
58
. Selecting Cancel
Document 900.0856
12/06
Advertisement
Table of Contents
