Operation
Clicking
position the mouse pointer at the bottom of the screen. Change the toolbar location by
clicking the empty space on the left side of the toolbar and drag it to where you want it
located on the screen. Use the arrow buttons on the toolbar to pan or tilt the camera in
the direction you want. The other controls on the toolbar perform as described below:
Image Adjustment
If a user who has Color Control authority logs in, the user can adjust the image.
Pressing and holding a camera button for a few seconds displays an image adjustment
dialog. You can control brightness, contrast, hue and saturation for each camera.
Event Monitoring
When an event occurs, the DVR will display the camera associated with the event if
Event Monitoring On is selected in the Display setup screen (OSD tab).
How the cameras are displayed depends on the number of cameras associated with
the event. If one camera is associated with the event, the DVR will display the camera
full screen. If two to four cameras are associated with the event, the DVR will display the
Rev 1.00
on the left side exits the toolbar. If you want to display the toolbar again,
Table 4-1
PTZ Controls
Note
It is important that cameras and monitors are correctly installed
and adjusted prior to making any image adjustments using the
DVR's controls.
Note
Any image adjustments you make will be applied to both the live
video on the monitors and the recorded video.
Zoom In/Out
Focus Near/Far
Iris Open/Close
Set/Load Preset
84
Document 900.0856
12/06