Factory Reset; Figure 2-10 Factory Reset Switch - Honeywell HRHD 410 User Manual

Installation

Factory Reset

The DVR has a Factory Reset switch to the right of the RS232C connector. This switch
will only be used on the rare occasions that you want to return all the settings to the
original factory default settings.
Caution
Caution
To reset the unit, you need a straightened paper clip:
1.
2.
3.
4.
Rev 3.03
Note The DVR is not supplied with a modem cable, and many
modems are not supplied with cables. Make certain you have the
correct cable when purchasing the modem.
Figure 2-10
RS - 232C
When using the Factory Reset, you will lose any settings you have
made.
If you wish to use the same DVR name registered on the DVRNS
server after initializing the system using the factory reset, you
need to contact the DVRNS server manager. Please record and
save the help desk information before performing a factory reset.
Turn the DVR off.
Turn it on again.
While the DVR is initializing, poke a straightened paper clip in the unlabeled hole
to the right of the USB port.
Hold the switch until all the LEDs on the front panel are lit.
Factory Reset Switch
Factory reset
switch
11 Document 900.0315
02/07