Factory Reset; Connecting The Power Cord; Figure 2-14 Factory Reset Switch; Figure 2-15 Power Cord Connector - Honeywell HRSD8 User Manual

Installation

Factory Reset

The DVR has a Factory Reset switch to the left of the Alarm Output connectors on the
rear panel. This switch should be used only on the rare occasions that you want to
return all the settings to the original factory settings.
Caution
To reset the unit, you need a straightened paperclip:
1.
2.
3.
4.
5.

Connecting the Power Cord

Connect the AC power cord to the DVR and then to a wall outlet.
Document 800-03650 Rev D
02/09
Figure 2-14 Factory Reset Switch
When you use the Factory Reset, you lose any settings you have
saved.
Turn off the DVR.
Turn it on again.
While the DVR is initializing, the front panel LEDs blink. When the front panel LEDs
blink, poke the straightened paperclip to the unlabeled hole in the left of the Alarm
Output connectors.
Hold the switch until all the LEDs on the front panel are lit.
Note When the DVR successfully resets to factory defaults all the LEDs
on the front panel flash five times.
Release the reset switch. All of the DVR's settings are now at the original settings it
had when it left the factory.
Figure 2-15 Power Cord Connector
29