Table of Contents
Advertisement
Operation
The zone should be placed or focused on the center or, at least, within the outline of
targeted object.
Highlight the box beside Sensitivity and press
sensitivity) to 5 (high sensitivity).
Highlight the box beside Min. Blocks and press
of sensor blocks that must be activated. Setting the Min Blocks will only be available if
Motion Search is selected.
Once you set your desired search conditions, highlight Search and press
the search results in the Motion Search screen. Selecting Cancel exits the screen
without saving the changes.
When you search for motion events of another camera, you will be asked whether or
not you want to delete the previous search results from the list.
Clip-Copy Screen
The Clip-Copy screen can be used to copy video clips to an internal CD-RW or DVD
RW drive, or external USB hard disk, CD-RW or flash drive. The copied video clips can
be viewed on computers running Microsoft Windows 98, ME, 2000 or XP. Refer to
Appendix A, USB Hard Disk Drive Preparation
drive for clip copy. The clip copy can be simply done by pressing MENU or FREEZE.
Press and hold MENU for more than two seconds while in the Search mode, and the
Clip-Copy screen appears to allow clip copy setup.
Pressing FREEZE during the playback will set the starting point of the video to be clip
copied, and the
FREEZE again will set the ending point of the video to be clip copied by displaying the
Clip-Copy screen.
Pressing and holding FREEZE for more than two seconds while in Search mode or Live
Monitoring mode initiates the One-Touch Clip Copy function. The last recorded image
will be the ending point of video to be clip copied, and the system will automatically
begin to calculate the possible video data size that the selected storage media can
handle.
Rev 1.00
Note
When setting the Museum Search Zone, the zone should be
placed inside of the border line of the target object. If the
selected block is placed on the border line, the sensitivity of the
Museum Search may decrease.
icon displays at the bottom-left corner of the screen. Pressing
. You will be able to select from 1 (low
. You will be able to set the number
for information on preparing the external
101
to display
Document 900.0856
12/06
Advertisement
Table of Contents
