Configuration
Highlight the box beside Port and select from None, RS232 and RS485. If the RS232
port and RS485 port are in use for PTZ control, networking or text input, the remote
keyboard cannot be configured.
Highlight Setup... and select the correct Baud Rate, Parity, Data Bits and Stop Bits for
the device you are connecting to the DVR.
Highlight the box beside Remote Control Product and select the device from the list.
You can save your Remote Control settings by highlighting Save and pressing
Selecting Cancel exits the screen without saving the changes.
Recording Settings
Your DVR offers a variety of flexible recording modes. You can set it up to record all the
time or to only record events. It can be set up to continue recording once the hard disk
drive is full by recording over the oldest video, or you can set it up to alert you when the
hard disk is full and stop recording.
Rev 1.00
Figure 3-47
Remote Control Setup Screen
Figure 3-48
Record Menu
54
.
Document 900.0856
12/06