Check Installed Clearance; Check Gear Tooth - Chery Tiggo 2009 Service Manual

6.
CHECK CKP SENSOR
• Check resistance as table shown.
• Remove the sensor.
• Visually check the sensor for chipping.
TERMINAL NO.
1 & 2
Is the check result normal?
Yes >>
Replace the CKP sensor with a known good CKP sensor.
Monitor the CKP sensor signal on the KES-200 screen.
− If the CKP sensor signals were normal, the system is OK.
− If the CKP sensor signals were still irregular or missing, go to step 7.
No >>
Replace or clear CKP sensor.
7.

CHECK INSTALLED CLEARANCE

• Check the installed clearance (See Crankshaft Position (CKP) Sensor Removal & Installation in Section 08
Transaxle & Transfer Case).
• 0.8 - 1.2 mm should exist.
Is the check result normal?
Yes >>
Go to the next step.
No >>
Reinstall CKP sensor.
8.

CHECK GEAR TOOTH

• Visually check for chipping signal plate gear tooth.
Is the check result normal?
Yes >>
Go to the next step.
No >>
Replace the signal plate
Chery Automobile Co., Ltd.
DIAGNOSIS & TESTING
RESISTANCE (25°C)
Approximately 860
03
175
03–