3.1.9. Remove the air conditioner cover plate assembly.
3.1.10. Tear open the sponge around the inlet/outlet water pipes and
remove the fixing clips.
3.1.11. Remove the heater exchanger.
3.2. Installation Steps
The installation steps are reverse to those for removal.
After the installation, the system should be evacuated, proper
pressure should be maintained and anti-freeze agent should be filled
to check for any leakage. Check if the radiator is blocked and
pressure air can be used to get it through if it is.
4. Removal and Installation of Mode Throttle Related Mechanism
4.1. Removal of Steps
4.1.1. Remove the mode throttle hitch bar, use a cross head
screwdriver to lossen off the fixing screws on the control panel to
disassemble.