Output Solo Selection - SoundCraft VI6 User Manual

Output Solo Selection

Output Solo Selection allows an individual output solo to be sent only to a specific monitor output (Mon
A, B or Phones). This is useful for stage monitoring applications where the solos of in-ear monitor mixes
could be programmed to appear only on Monitor B for example, which could have an in-ear headphone
system connected to it. In this example, conventional wedge monitor mixes could be programmed to
appear only on Monitor A when soloed, where Monitor A could be connected to a wedge speaker system.
OUT SOLO A field
Displays the Busses which are included in the OUT SOLO selection (default ALL) for Monitor A. Its VST
{config button} opens the OUT SOLO Group configuration page (Figure 11-8).
OUT SOLO B field
Displays the Busses which are included in the OUT SOLO selection (default ALL) for Monitor B. Its {VST
config button} opens the OUT SOLO Group configuration page (Figure 11-8).
OUT SOLO HP field
Displays the Busses which are included in the OUT SOLO selection (default ALL) for the headphones. Its
{VST config button} opens the OUT SOLO selection configuration page (Figure 11-8).
Figure 11-8: Output Solo Selection Page
Each of the 32 outputs can be switched in or out of the output monitoring group, for each of the 3 moni-
toring circuits. The <NONE> key deselects all of them. <EXIT> makes the display go back to the previous
page. The selctions made are mirrorred in the small OUT SOLO areas of the VST area. The colours indicate
the type of each output: Aux Group or Matrix.
Page 11 - 10 Soundcraft Vi6™ User Guide