FX Overview Page
In the Overview Page all eight FX processors are visible at the same time and can also be adjusted. The
parameters available for adjustment will depend upon the type of FX which is selected. A description of the
Effects and their associated controls is given in the section which starts on page 13 of this chapter.
To enter the FX Overview Page press [MENU] and select the FX Tab.
The vertical white Bars on the Boxes represent the assignment mode : In INSERT mode the white bars are
inside (example below LEX 1 = Channel Insert, LEX 2 = Master Insert). In PATCH mode the white bars are
outside (exampled below LEX 3 = Patch). Note that the bars should both be outside or should both be
inside.
The vertical white bars also indicate for each FX processor if a mono or stereo format is being used. In the
example below LEX 1 is in a stereo format, all the others are in a mono format.
Figure 21-2: FX Overview Page.
HINT. The assignment of the FX processors is visible, but cannot be changed from this page.
It is recommended that before assigning any FX processor this page should be viewed to find
out what processors are free (if any). If it is necessary to unassign a processor in order to use it
somewhere else it is strongly recommended that the user should unassign all patches to it
before re-patching it in its new location.
Snapshot integration
All Parameters from all Effect Types for each of the eight processors are stored in the console Snapshots.
In the Basic implementation each of the 8 FX processors can be fully isolated.
Page 21 - 2
Soundcraft Vi6™ User Guide