Meters On The Master Section Screen
The meter panel is always visible if [Meter Lock] is enabled, unless a SETUP or configuration is active.
If [Meter Lock] is disabled and a Solo/Sel button from a master is active, the meter panel will be tempo-
rarily replaced by the master processing view.
The upper region shows all 32 Bus levels, while the lower part shows all 64 input levels.
To enhance the overview, the input levels are split into two rows that correspond to the Channels in Fixed
layer A (1-32) and Fixed layer B (33-64).
Stereo Busses are indicated by the two meters being joined at the lower end of the bar.
Paired Input channels are displayed with a white border, showing either horizontal or vertical pairing.
Figure 13-4: Meters On The Master Section Screen
Touch Selection
The input meter overview is also touch-sensitive and allows blocks of 8 input channels to be selected and
assigned to the far right-hand bay of the console surface. A highlighted border indicates which, if any,
block of 8 channels has been selected; the [A] or [B] key on the Input Fader Pages panel also flashes to
indicate the temporary activation of the right-hand bay. The selection can be cancelled in one of three
ways:
i) by touching another 8-channel block on the input meter screen,
ii) touching the same block again, or
iii) pressing one of the [A] or [B] buttons mentioned above.
Soundcraft Vi6™ User Guide
Page 13 - 3