SoundCraft VI6 User Manual page 209

output and down on the other, and panning the two outputs hard left and right.
MODULATED EFFECT CONTROLS
Speed
Sets the speed at which the modulated effect cycles.
Depth
Scales the intensity of the effect. This control affects the output of the LFO only. It has no effect on the
outputs of the individual waveforms.
Voices
Controls the number of additional Chorus voices.
Regen
Controls the amount of modulated signal being fed back into the input, creating feedback. Higher amounts
add more resonance to the signal.
Diffusion
Creates a time-smoothing effect similar to diffusion in reverb. Diffusion can be a subtle effect to add a
little warmth to the chorus.
PreDelay
Determines the amount of offset between the two signals that create the flange effect. Lower values create
a tighter effect, higher values result in a more extreme "whooshing" sound.
Waveform
Selects the wave pattern used by the modulated effect.
Phase
Controls whether amplitude or depth change occurs in both left and right outputs simultaneously or
alternates between left and right outputs.
Phase Stages
Selects between a 4, 8, or 12 state phase shifter.
Stereo Spread
Increases or decreases the stereo imaging of the Rotary effect.
Drive
Provides overdrive gain to the preamp section of the rotary speaker effect.
Minimum Speed
Sets the minimum speed at which the effect will oscillate.
Maximum Speed
Sets the maximum speed at which the effect will oscillate.
Doppler
Increases or decreases the Doppler pitch effect that is created by the physics of a rotating speaker.
Soundcraft Vi6™ User Guide Page 21 - 19