Input Bay Strip Using [All Busses] - SoundCraft VI6 User Manual

INPUT BAY STRIP USING [ALL BUSSES]

The second method of controlling, and changing the parameters of, the 32 output busses described earlier
is as follows.
If the [ALL BUSSES] key is active (see Figure 8-6), the input strips on all of the input bays will be switched
to control the 32 output busses.
Once this is done, the user can select the desired fader to control the required output level. In addition, the
VST encoders can be used to change the bus type (Aux, Grp or Mtx) and format (Mono or Stereo).
In order to change the parameters for EQ, Dynamics or Pan, the appropriate area on the touch-screen
above the required strip must be pressed; doing so will open a page similar to Figures 5-9, 5-10 or 5-11.
Figure 5-5.Intput Bay Strip With [ALL BUSSES] Active.
Soundcraft Vi6™ User Guide Page 5 - 7