Copying Fx Parameters - SoundCraft VI6 User Manual

COPYING FX PARAMETERS

Parameter settings from any of the 8 internal Lexicon FX units can be copied from one device and pasted
to another.
To make selection of the source and destination units easy, a set of 8 FX-select encoders appears on the
central screen in both Copy and Paste modes. The selection is made by either touching the relevant
encoder or pressing the corresponding Vistonics button beside the encoder.
Alternatively, if the FX unit is assigned to a channel or bus and is therefore visible on the channel or bus
strip, then the source and destination units can be selected by touching the FX block on the channel strip.
Note that only the parameters relating to the currently active FX Type are copied and pasted for each unit –
so for example if LEX1 is currently set to the Small Hall FX type, then only the Small Hall parameters will
be copied, if LEX1 is selected to copy.
When the settings are pasted to another unit, the target unit will have its FX Type changed to Small Hall,
and only the Small Hall parameters will be pasted. None of the other 28 FX Types within the target FX unit
will have their settings changed.
Figure 18-5: The 8 FX-select encoders in Copy mode with LEX2 selected
To copy an FX unit's settings to the clipboard:
. Press [COPY]
. Select the required FX Unit, either using the FX Select Encoders displayed in the central
screen, or touching the FX unit's icon on the Channel or Bus strip, if one has been assigned and
is visible on the strip.
Parameters are copied to the clipboard
Soundcraft Vi6™ User Guide Page 18 - 5