Return In Channel Section - SoundCraft VI6 User Manual

Return in Channel section

This is the classical operation mode for Reverb Effects. The Output of an AUX Master is patched to the
Input of an FX Unit, and the Output of the FX Unit is patched to either a mono or 2 paired (Stereo) Input
Channels that mixes the Reverb content to the Main Masters or other destinations.
Figure 21-11: FX Return Via An Input Channel.
Patch an FX processor from an AUX Master to the Input section
Press the [ALL BUSSES] key.
Press the <PAN> area on the desired AUX Master bus.
Press the {BUS OUT} key to open the Output Patch page (see Figure 21-12). Press <Lexicon In> to
open the FX selection options.
If the Aux bus is mono, you should select both Left and Right Lexicon In patches.
If the Aux bus is stereo, you should patch the Left bus out to the Left Lexicon In, and the Right bus
to the Right Lexicon In.
Select the required FX processor. If the processor is in use, a dialog asks if you want to move it from
its current location. Press <EXIT>.
Press the Fixed Fader Page [A] or [B] key to select the required bank of input channels.
Press the <INPUT> area on the desired return Input Channel.
Press {IN1 PATCH} to open the Input Patch page (see Figure 21-13). Press <Lexicon Out> to open
the FX selection options.
Select the desired FX processor. If the processor is in use, a dialog asks if you want to move it from
its current location. Press <EXIT>.
Soundcraft Vi6™ User Guide Page 21 - 9