Safety Information; Important Safety Instructions - Panasonic NN-CT890S Operating Instructions And Cookery Book

Important safety instructions

Please read carefully and keep for future reference
This appliance is supplied with a moulded three
pin mains plug for your safety and convenience.
A 13 amp fuse is fitted in this plug. Should the
fuse need to be replaced, please ensure that the
replacement fuse has a rating of 13 amps and
that it is approved by ASTA or BSI to BS1362.
Check for the ASTA mark
on the body of the fuse.
If the fuse cover is detachable, never use the
plug with the cover omitted. If a replacement
fuse cover is required, ensure it is the same
colour as that visible on the pin face of the
plug.
A replacement fuse cover can be purchased
from your local Panasonic
Dealer.
HOW TO REPLACE THE FUSE
Open the fuse compartment
with a screwdriver and replace the fuse.
IF THE FITTED MOULDED PLUG IS
UNSUITABLE FOR THE SOCKET OUTLET IN
YOUR HOME THEN THE FUSE SHOULD BE
REMOVED AND THE PLUG CUT OFF AND
DISPOSED OF SAFELY AND AN APPROPRIATE
ONE FITTED. THERE IS A DANGER OF
SEVERE ELECTRICAL SHOCK IF THE CUT
OFF PLUG IS INSERTED INTO ANY 13 AMP
SOCKET.
If a new plug is to be fitted, please observe the
wiring code as shown below. If in any doubt,
please consult a qualified electrician (For U.K.
Models only).
WARNING: THIS APPLIANCE MUST BE
EARTHED.
IMPORTANT: The wires in this mains lead are
coloured in accordance with the following code:
Green-and-yellow: Earth, Blue: Neutral, Brown:
Live.
or the BSI mark
2
As the colours of the wire in the mains lead of
this appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
The wire which is coloured GREEN-AND-
YELLOW must be connected to the terminal in
the plug which is marked with the letter E or by
the Earth symbol
GREEN-AND-YELLOW.
The wire which is coloured BLUE must be
connected to the terminal in the plug which is
marked with the letter N or coloured BLACK.
The wire which is coloured BROWN must be
connected to the terminal in the plug which is
marked with the letter L or coloured RED.
When this oven is installed it should be easy to
isolate the appliance from the electricity supply by
pulling out the plug or operating a circuit breaker.
Voltage & Power
The voltage used must be the same as
specified on this microwave oven. Using a
higher voltage than that which is specified is
dangerous and may result in a fire or other
type of accident causing damage.
Do not immerse cord, plug or oven in water. Keep
cord away from heated surfaces. Do not let cord
hang over the edge of table or work top. Do not
plug your oven in via an extension cable as this
can be dangerous. It is important to plug the oven
directly into a wall socket.
The back of the appliance heats up during use.
Do not allow the cord to be in contact with the
back of the appliance or cabinet surface.
or coloured GREEN or