Safety Information - Panasonic NNE252WB Operating Instructions And Cookery Book

Important safety instructions
Please read carefully and keep for future reference
This appliance is supplied with a moulded three
pin mains plug for your safety and convenience.
A 13 amp fuse is fitted in this plug. Should the
fuse need to be replaced, please ensure that
the replacement fuse has a rating of 13 amps
and that it is approved by ASTA or BSI to
BS1362. Check for the ASTA mark
BSI mark on the body of the fuse.
If the fuse cover is detachable, never use
the plug with the cover omitted. If a
replacement fuse cover is required, ensure it
is the same colour as that visible on the pin
face of the plug. A replacement fuse cover
can be purchased from your local Panasonic
Dealer.
HOW TO REPLACE THE FUSE
Open the fuse
compartment with a
screwdriver and
replace the fuse.
IF THE FITTED MOULDED PLUG IS
UNSUITABLE FOR THE SOCKET OUTLET IN
YOUR HOME THEN THE FUSE SHOULD BE
REMOVED AND THE PLUG CUT OFF AND
DISPOSED OF SAFELY AND AN
APPROPRIATE ONE FITTED. THERE IS A
DANGER OF SEVERE ELECTRICAL SHOCK
IF THE CUT OFF PLUG IS INSERTED INTO
ANY 13 AMP SOCKET.
If a new plug is to be fitted, please observe the
wiring code as shown opposite. If in any doubt,
please consult a qualified electrician (For U.K.
Models only).
WARNING: THIS APPLIANCE MUST BE
EARTHED.
2
IMPORTANT: The wires in this mains lead are
coloured in accordance with the following code:
Green-and-yellow: Earth. Blue: Neutral. Brown:
Live.
As the colours of the wire in the mains lead of
this appliance may not correspond with the
or the
coloured markings identifying the terminals in
your plug, proceed as follows:
The wire which is coloured GREEN-AND-
YELLOW must be connected to the terminal in
the plug which is marked with the letter E or by
the Earth symbol
GREEN-AND-YELLOW.
The wire which is coloured BLUE must be
connected to the terminal in the plug which is
marked with the letter N or coloured BLACK.
The wire which is coloured BROWN must be
connected to the terminal in the plug which is
marked with the letter L or coloured RED.
When this oven is installed it should be easy to
isolate the appliance from the electricity supply
by pulling out the plug or operating a circuit
breaker.
Voltage & Power
The voltage used must be the same as
specified on this microwave oven. Using a
higher voltage than that which is specified
is dangerous and may result in a fire or
other type of accident causing damage.
Do not immerse cord, plug or oven in water.
Keep cord away from heated surfaces. Do not
let cord hang over the edge of table or work top.
Do not plug your oven in via an extension cable
as this can be dangerous. It is important to plug
the oven directly into a wall socket.
The back of the appliance heats up during use.
Do not allow the cord to be in contact with the
back of the appliance or cabinet surface.
or coloured GREEN or