Setting The Port Security Mode - 3Com 4510G Configuration Manual

Follow these steps to set the maximum number of secure MAC addresses allowed on a port:
To do...
Enter system view
Enter Ethernet port view
Set the maximum number of
secure MAC addresses
allowed on a port
This configuration is different from that of the maximum number of MAC addresses that can be leaned
by the port in MAC address management.

Setting the Port Security Mode

Configuration Prerequisites
Before setting the port security mode, ensure that:
802.1X is disabled, the port access control method is macbased, and the port access control
mode is auto.
MAC authentication is disabled.
The port does not belong to any aggregation group.
The above requirements must be all met. Otherwise, you will see an error message and your
configuration will fail. On the other hand, after setting the port security mode on a port, you cannot
change any configurations of the first three requirements.
With port security disabled, you can configure the port security mode, but your configuration does
not take effect.
You cannot change the port security mode of a port when any user is present on the port.
Before configuring the port to operate in autoLearn mode, set the maximum number of secure
MAC addresses allowed on a port.
Use the command...
system-view
interface interface-type
interface-number
port-security max-mac-count
count-value
6-6
Remarks
—
—
Required
Not limited by default