Configuring Trap Delivery - 3Com 4510G Configuration Manual

To do...
Create a Track object and
associate it with the
specified collaboration
object of the NQA test
group
You cannot modify the content of a reaction entry using the reaction command after the
collaboration object is created.
The collaboration function is not supported in a UDP jitter or voice test.

Configuring Trap Delivery

Traps can be sent to the network management server when test is completed, test fails or probe fails.
Configuration prerequisites
Before configuring trap delivery, you need to configure the destination address of the trap message
with the snmp-agent target-host command, create an NQA test group, and configure related
parameters. For the introduction to the snmp-agent target-host command, see SNMP Commands in
the System Volume.
Configuring trap delivery
Follow these steps to configure trap delivery:
To do...
Enter system view
Enter NQA test group view
Enter test type view of the test
group
Configure to send traps to
network management server
under specified conditions
Only the reaction trap test-complete command is supported in a voice test, namely, in a voice test,
traps are sent to the NMS only if the test succeeds.
Use the command...
track entry-number nqa entry
admin-name operation-tag reaction
item-num
Use the command...
system-view
nqa entry admin-name
operation-tag
type { dhcp | dlsw | ftp | http |
icmp-echo | snmp | tcp |
udp-echo | udp-jitter | voice }
reaction trap { probe-failure
consecutive-probe-failures |
test-complete | test-failure
cumulate-probe-failures }
22-19
Remarks
Required
Not created by default.
Remarks
—
—
—
Optional
No traps are sent to the
network management server
by default.