Displaying And Maintaining Ipv6 Acls; Ipv6 Acl Configuration Example - 3Com 4510G Configuration Manual

The source IPv6 ACL and the destination IPv6 ACL must be of the same type.
The destination ACL does not take the name of the source IPv6 ACL.

Displaying and Maintaining IPv6 ACLs

Display information about one or all
IPv6 ACLs
Display information about ACL uses of
a switch
Display the configuration and status on
time range
Clear statistics about a specified or all
IPv6 ACLs that are referenced by upper
layer software

IPv6 ACL Configuration Example

Network Requirements
As shown in Figure
Configure an ACL to deny access of the R&D department to external networks.
Figure 15-1 Network diagram for IPv6 ACL configuration
Configuration Procedure
# Create an IPv6 ACL 2000.
<Switch> system-view
[Switch] acl ipv6 number 2000
[Switch-acl6-basic-2000] rule deny source 4050::9000/120
[Switch-acl6-basic-2000] quit
# Configure class c_rd for packets matching IPv6 ACL 2000.
To do...
15-1, a company interconnects its departments through the switch.
Use the command...
display acl ipv6 { acl6-number | all |
name acl6-name }
display acl resource
display time-range
{ time-range-name | all }
reset acl ipv6 counter
{ acl6-number | all | name
acl6-name }
15-5
Remarks
Available in any
view
Available in any
view
Available in any
view
Available in user
view