Displaying And Maintaining The Tftp Client - 3Com 4510G Configuration Manual

Follow these steps to configure the TFTP client:
To do...
Enter system view
Control the access to the TFTP
servers from the device
through ACL
Configure the source address
of the TFTP client
Return to user view
Download or upload a file in an
IPv4 network
Download or upload a file in an
IPv6 network
If no primary IP address is configured on the source interface, no TFTP connection can be
established.
If you use the ftp client source command to first configure the source interface and then the
source IP address of the packets of the TFTP client, the new source IP address will overwrite the
current one, and vice versa.

Displaying and Maintaining the TFTP Client

To do...
Display the configuration of the
TFTP client
Use the command...
system-view
tftp-server [ ipv6 ] acl
acl-number
tftp client source { interface
interface-type interface-number
| ip source-ip-address }
quit
tftp server-address { get | put |
sget } source-filename
[ destination-filename ]
[ source { interface
interface-type interface-number
| ip source-ip-address } ]
tftp ipv6 tftp-ipv6-server [ -i
interface-type
interface-number ] { get | put }
source-file [ destination-file ]
Use the command...
display tftp client
configuration
13-3
Remarks
—
Optional
By default, the access to the
TFTP servers from the device
is not controlled.
Optional
A device uses the source
address determined by the
matched route to communicate
with the TFTP server by
default.
—
Optional
Available in user view
Optional
Available in user view
Remarks
Available in any view