Configuring The Nqa Server; Enabling The Nqa Client; Creating An Nqa Test Group - 3Com 4510G Configuration Manual

Configuring Optional Parameters Common to an NQA Test Group
Scheduling an NQA Test Group

Configuring the NQA Server

Before performing TCP, UDP echo, UDP jitter or voice tests, you need to configure the NQA server on
the peer device. The NQA server makes a response to the request originated by the NQA client by
listening to the specified destination address and port number.
Follow these steps to configure the NQA server:
To do...
Enter system view
Enable the NQA server
Configure the UDP or TCP
listening function on the NQA
server

Enabling the NQA Client

Configurations on the NQA client take effect only when the NQA client is enabled.
Follow these steps to enable the NQA client:
To do...
Enter system view
Enable the NQA client

Creating an NQA Test Group

One test corresponds to one test group. You can configure test types after you create a test group and
enter the test group view.
Follow theses steps to create an NQA test group:
To do...
Enter system view
Create an NQA test group and
enter the NQA test group view
Task
Use the command...
system-view
nqa server enable
nqa server { tcp-connect |
udp-echo } ip-address
port-number
Use the command...
system-view
nqa agent enable
Use the command...
system-view
nqa entry admin-name
operation-tag
22-5
Remarks
Optional
Required
Remarks
—
Required
Disabled by default.
Required
The IP address and port
number must be consistent
with those configured on the
NQA client and must be
different from those of an
existing listening service.
Remarks
—
Optional
Enabled by default.
Remarks
—
Required