3Com 4510G Configuration Manual page 257

Configuration procedure
1) Configure Switch A
# Enable the DHCP client on VLAN-interface 2.
<SwitchA> system-view
[SwitchA] interface vlan-interface 2
[SwitchA-Vlan-interface2] ip address dhcp-alloc
2) Verification
# Use the display dhcp client command to view the IP address and other network parameters
assigned to Switch A.
[SwitchA-Vlan-interface2] display dhcp client verbose
Vlan-interface2 DHCP client information:
Current machine state: BOUND
Allocated IP: 10.1.1.3 255.255.255.0
Allocated lease: 864000 seconds, T1: 432000 seconds, T2: 756000 seconds
Lease from 2009.02.20 11:06:35
DHCP server: 10.1.1.1
Transaction ID: 0x410090f0
Classless static route:
Destination: 20.1.1.0, Mask: 255.255.255.0, NextHop: 10.1.1.2
DNS server: 20.1.1.1
Client ID: 3030-3066-2e65-3230-
302e-3030-3032-2d45-
7468-6572-6e65-7430-
2f30
T1 will timeout in 4 days 23 hours 59 minutes 50 seconds.
# Use the display ip routing-table command to view the route information on Switch A. A static route
to network 20.1.1.0/24 is added to the routing table.
[SwitchA-Vlan-interface2] display ip routing-table
Routing Tables: Public
Destinations : 5
Destination/Mask
10.1.1.0/24 Direct 0
10.1.1.3/32 Direct 0
20.1.1.0/24 Static 70
127.0.0.0/8 Direct 0
127.0.0.1/32
to 2009.03.02 11:06:35
Routes : 5
Proto Pre Cost
0
0
0
0
Direct 0 0
NextHop Interface
10.1.1.3 Vlan2
127.0.0.1 InLoop0
10.1.1.2 Vlan2
127.0.0.1 InLoop0
127.0.0.1 InLoop0
7-3