Configuring Command Accounting - 3Com 4510G Configuration Manual

To do...
Enter AUX user interface view
Enable command authorization

Configuring Command Accounting

Command accounting allows the HWTACACS server to record all commands executed on the device
regardless of the command execution result. This helps control and monitor the user operations on the
device.
If command accounting is enabled and command authorization is not enabled, every executed
command will be recorded on the HWTACACS server. If both command accounting and command
authorization are enabled, only the authorized and executed commands will be recorded on the
HWTACACS server.
The command accounting configuration involves two steps:
1) Enable command accounting. See the following table for details.
2) Configure a command accounting scheme. Specify the IP address and other related parameters
for the accounting server. For details, refer to the AAA Configuration in the Security Volume.
Follow these steps to enable command accounting:
To do...
Enter system view
Enter AUX user interface view
Enable command accounting
Use the command...
0
user-interface aux
command authorization
Use the command...
system-view
user-interface aux 0
command accounting
2-12
Remarks
—
Required
Disabled by default, that is,
users can execute commands
without authorization.
Remarks
––
––
Required
Disabled by default, that is, the
accounting server does not
record the commands the
users execute.