Configuring Protected Vlans For A Smart Link Group; Configuring Member Ports For A Smart Link Group - 3Com 4510G Configuration Manual

Configuring Protected VLANs for a Smart Link Group

Follow these steps to configure the protected VLANs for a smart link group:
To do...
Enter system view
Create a smart link group and enter
smart link group view
Configure protected VLANs for the
smart link group
The protected-vlan command configures protected VLANs for a smart link group by referencing
MSTIs. To view VLAN-to-MSTI mappings, use the display stp region-configuration command. For
VLAN-to-MSTI mapping configuration, refer to MSTP Configuration in the Access Volume.

Configuring Member Ports for a Smart Link Group

You can configure member ports for a smart link group either in smart link group view or in interface
view. The configurations made in these two views have the same effect.
In smart link group view
Follow these steps to configure member ports for a smart link group in smart link group view:
Enter system view
Create a smart link group and enter
smart link group view
Configure member ports for a smart
link group
In interface view
Follow these steps to configure member ports for a smart link group in interface view:
Enter system view
Enter Ethernet interface view or layer 2
aggregate interface view
system-view
smart-link group group-id
protected-vlan reference-instance
instance-id-list
To do...
To do...
Use the command...
Use the command...
system-view
smart-link group group-id
port interface-type
interface-number { master |
slave }
Use the command...
system-view
interface interface-type
interface-number
1-5
Remarks
—
—
Required
By default, no
protected VLAN is
configured for a smart
link group.
Remarks
—
—
Required
Remarks
—
—