Configuring Role Preemption For A Smart Link Group; Enabling The Sending Of Flush Messages - 3Com 4510G Configuration Manual

Configure member ports for a smart
link group

Configuring Role Preemption for a Smart Link Group

Follow these steps to configure role preemption for a smart link group:
Enter system view
Create a smart link group and enter
smart link group view
Enable role preemption
Configure the preemption delay
The preemption delay configuration takes effect only after role preemption is enabled.

Enabling the Sending of Flush Messages

Follow these steps to enable the sending of flush messages:
Enter system view
Create a smart link group and enter
smart link group view
Enable flush update in the specified
control VLAN
To do...
To do...
To do...
Use the command...
port smart-link group group-id
{ master | slave }
Use the command...
system-view
smart-link group group-id
preemption mode role
preemption delay delay-time
Use the command...
system-view
smart-link group group-id
flush enable [ control-vlan
vlan-id ]
1-6
Remarks
Required
Remarks
—
—
Required
Disabled by default.
Optional
1 second by default
Remarks
—
Required
Optional
By default, flush
update is enabled,
and VLAN 1 is the
control VLAN.