User Manual of DS-9100HWI-ST Series DVR
5.1 Configuring Encoding Parameters
Purpose:
By configuring the encoding parameters you can define the transmission stream type the resolution and so on.
Before you start:
1.
Make sure that the HDD has already been installed. If not, please install a HDD and initialize it.
(Menu>HDD>General)
2.
Check the storage mode of the HDD
1)
Click Advance to check the storage mode of the HDD.
2)
If the HDD mode is Quota, please set the maximum record capacity and maximum
picture capacity. For detailed information, see Chapter 10.5 Configuring Quota Mode.
3)
If the HDD mode is Group, you should set the HDD group. For detailed information, see
Chapter 5.9 Configuring HDD Group for Recording and Capture.
Steps:
Figure 5.1 HDD-‐ General
Figure 5.2 HDD-‐ Advanced
48