Table of Contents
Advertisement
User Manual of DS-7200HVI/HFI-SH Series DVR
5.1 Configuring E ncoding Parameters
Purpose:
By configuring the encoding parameters you can define the transmission stream type, the resolution and so on.
Before you start:
1. Make sure that the HDD has already been installed. If not, please install a HDD and initialize it.
(Menu>HDD>General)
2. Check the storage mode of the HDD
1) Click A dvance to check the storage mode of the HDD.
2) If the HDD mode is Quota , please set the maximum record capacity and maximum picture capacity.
For detailed information, see Chapter 10.5 Configuring Quota Mode .
3) If the HDD mode is Group , you should set the HDD group. For detailed information, see Chapter
5.9 Configuring H D D Group for Recording .
Steps:
1. Enter the Record settings interface to configure the encoding parameters:
Menu>Record>Encoding
Figure
5 .1
H DD-‐
G eneral
Figure
5 .2
H DD-‐
A dvanced
48
Advertisement
Table of Contents
