Table of Contents
Advertisement
User Manual of DS-9100HWI-ST Series DVR
9.1 Configuring General Settings
Purpose:
Network settings must be properly configured before you operate DVR overnetwork.
Steps:
1.
Enter the Network Settings interface.
Menu >Configuration>Network
Figure 9.1 Network Settings Interface for DS-‐9100HWI-‐ST
2.
Select the General tab.
3.
In the General Settings interface, you can configure the following settings: Working Mode, NIC Type,
IPv4 Address, IPv4 Gateway, MTU and DNS Server.
If the DHCP server is available, you can click the checkbox ofDHCP to automatically obtain an IP
address and other network settings from that server.
Note: The valid value range of MTU is 500 ~ 9676.
4.
After having configured the general settings, click the Apply button to save the settings.
Working Mode
There are two 10M/100M/1000M NIC cards provided by the device, and it allows the device to work in the
Multi-address, Load Balance and Net-fault Tolerance modes.
Multi-address Mode:The parameters of the two NIC cards can be configured independently. You can select
LAN1 or LAN2 in the NIC type field for parameter settings.
You can select one NIC card as default route. And then the system is connecting with the extranet the data will
be forwarded through the default route.
136
Advertisement
Table of Contents
