Network Settings; Configuring General Settings; Configuring Hik-Connect - HIKVISION DS-7324HUHI-K4 Quick Start Manual

Power for PoC" is overlaid on
the live view image.
Step 3 Check the connected AF or AT camera number and the connectable camera number.
 Only Hikvision PoC camera is supported.
 The maximum connectable AT/AF camera number varies with different models.
 Do not unplug or plug the PoC camera if it is powered by the external power supply.

3.9 Network Settings

3.9.1 Configuring General Settings

Purpose
Network settings must be properly configured before you operate DVR over network.
Step 1 Go to Menu > Configuration >
Network > General.
Step 2 Configure the general parameters of
network.
Step 3 Click Apply to save the settings.

3.9.2 Configuring Hik-Connect

Purpose
Hik-Connect provides the mobile phone application and the service platform page (www.hik-connect.com) to
access and manage your connected DVR, which enables you to get a convenient remote access to the
surveillance system.
The Hik-Connect can be enabled via operation on SADP software, GUI and Web browser. We introduce the
operation steps on GUI in this section.
Step 1 Go to Menu > Configuration > Network >
Platform Access.
Digital Video Recorder Quick Start Guide
normally; when AT camera is
connected, it is powered on and
then powered off, and there is no
video and "Insufficient Power for
PoC" is overlaid on the live view
image.
11
Figure 3-9 Note on Live View Image
Figure 3-10 Network Settings
Figure 3-11 Hik-Connect Settings