Table of Contents
Advertisement
7.1.1.4 Network Setting
In the Network Setting dialog box, click Update to accept the new settings, click Exit to exit without
saving, and click Default to revert back to original factory setting. For the network service ports that
use by DVR server, please see
(1)
(2)
(1) Server Name
Assign a name for the DVR unit. Alphabet letters and numbers only.
(2) Transmitting Cameras
Select and click on the camera number in the Transmitting Camera section you want to make it
accessible via internet using WebViewer, Remote Console, PDA Viewer and JAVAViewer (still
image). To select all the cameras, enable the ALL check box.
(3) Network Time Synchronization
Adjust the DVR system time same as network time server. Fill in the Time Server IP
address or domain name. Select the Time Zone that DVR is located. And then, mark the
Automatic Synchronize time to set automatic synchronize time on a daily basis.
(4) Other Configuration
-
Enable White List
An access permit list for the remote accessing of DVR server. Enter the IP address and click
Add. Or, enter a range of IP address and click Add. To delete the IP from the list, select the
IP and click Delete button. To reset the input, click Clear button.
Appendix
A.
82
(3)
(4)
Advertisement
Table of Contents
