Table of Contents
Advertisement
c.
Select the hard disk from device list and select Format type
d.
Click Format button to start formatting
e.
When formatting is done, click OK.
5. Setup the date and time in order to have correct recording time and date. Following the below
steps to setup date and time:
a.
Click Setup and enter the password
b.
In Time section, click Setting button of System Time.
c.
Select the date and adjust the time, and then, click OK.
6. Following the below steps to connect the IP and analog camera.
To connect analog camera:
a. Plug the analog camera video cable into DVR video port.
b. Click Setup → Camera
c. Select camera channel and type of camera – Analog Camera
d. And then, enable the camera
e. Give a name of camera and enter short description.
f.
Adjust the bright, contrast, hue, and saturation of camera
g. Click OK
To connect IP camera:
a. Click Setup → Camera
b. Select camera channel and type of camera – IP Camera
c. And then, enable the camera
d. Click IP Setting
e. Enable Protocol, and then, select protocol, mode, video format, and channel of IP
camera.
f.
Enter IP address or URL of IP camera.
g. Enter ID and password if IP camera's access authority is required.
h. Click OK.
i.
To connect another IP camera, follow the above steps.
DVR unit can connect 16 cameras in analog and IP cameras combo.
i
–
DVR unit doesn't supply the power to connected external device.
–
2.1.2 Using the Virtual Keyboard
User can use the Virtual Keyboard when the keyboard is not available. Just click
screen to call out the virtual keyboard. For uppercase, click Caps button. To exit, click Esc.
18
or right-click
Advertisement
Table of Contents
