Table of Contents
Advertisement
Reboot: when the DVR system reboot without abnormal condition, the system will
send out the alarm message.
Abnormal Reboot: when the DVR system reboot in irregular condition, the system will
send out the alarm message.
Recording is switched off: when the recording has been stopped, the system will
send out the alarm message.
Network is switched off: when the network connection of DVR system is lost, the
system will send out the alarm message.
Hard Disk failed: when the hard disk doesn't work normally, the system will send out
the alarm message.
-
Continue trigger duration: Set a time period that when sensor has been trigger and stay in
the same status for that period, then the alarm will be sent out.
7. In (6) Alarm Reset, click the camera number to set the reset condition of alarm. Once alarm is
reset, all alarm action will stop at the moment. If the sensor normal status is high, set the alarm
reset condition to low.
8. In (7) Action, you may now set the alarm action for the system to perform when the alarm
condition is activated.
- Enlarge Camera View
Switch to only display video in Preview mode from where the alarm is activated.
a. Select the camera from drop down list to specify which camera video to be enlarged on
screen when the alarm is triggered.
b. Retrieve time: set the waiting duration before system switching back to original Preview
mode. If the retrieve time is un-mark, the alarm video will keep enlarging until user switch
back to Preview mode manually. The retrieve time range is 0~ 600 seconds.
120
Advertisement
Table of Contents
