Table of Contents
Advertisement
Subject: Enter the message title.
Message: Type the message.
-
Start Recording
Record the video from the selected
camera.
1. Beside the Start Recording check box,
click Detail.
2. In the Alarm Recording Setting dialog
box, select the camera to
enable/disable video recording.
Enable All to select all cameras.
3. In the Frame Rate selection, select
As Setting to record the number of
frames based on the Recording
Setting.
4. In the Start Record prior text box,
mark and set the number in second for the program to begin recording after the alarm has
been trigger. The time range is 1~10 seconds.
5. In the Stop Record after text box, mark and set the number in second for the program to
continue recording after the alarm has ended. The time range is 1~999 seconds. If user
doesn't mark and set the time, the alarm recording will continue recording until alarm is
reset.
6. Click OK to accept the new settings and Cancel to exit without saving.
- PTZ preset point
Position the PTZ camera based on the preset point
setting. Beside the PTZ preset point check box, click
Detail. In the Trigger PTZ Preset Setting dialog box,
select the PTZ camera number then select the Enable
check box. Select the position of the PTZ camera when
the alarm is activated and ended. For the PTZ camera
end point, user can also select on preset position or
Auto Pan between preset position groups.
- Send to CMS (Central Management System)
Enable/disable the selected camera to send
video to CMS when the alarm is activated.
Beside the Send to CMS check box, click
Detail. In the CMS Setting, select the camera
to enable/disable sending the video to CMS.
Enable All to select all cameras. Then, click
OK to accept the new settings and Cancel to
exit without saving.
57
Advertisement
Table of Contents
