Enable LLDP on the ports of Switch A and Switch B to monitor the link between Switch A and Switch B and
the link between Switch A and the MED device on the NMS.
Network diagram for basic LLDP configuration
a.
Configuration procedure
Table 61
Configure Switch A
# Enable LLDP on GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2. This step is optional, because LLDP
is enabled on Ethernet ports by default.
# Set the LLDP operating mode to Rx on GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2.
Select Network LLDP from the navigation tree to enter the Port Setup tab, as shown in b. Select port
GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 and click Modify Selected. The page shown in
appears.
239
c