HP V1910 User Manual page 233

Table 60 IEEE 802.3 organizationally specific TLVs
IEEE 802.3 organizationally specific TLVs
4.
Type
MAC/PHY Configuration/Status
Power Via MDI
Link Aggregation
Maximum Frame Size
LLDP-MED TLVs
LLDP-MED TLVs provide multiple advanced applications for voice over IP (VoIP), such as basic configuration,
network policy configuration, and address and directory management. LLDP-MED TLVs provide a
cost-effective and easy-to-use solution for deploying voice devices in Ethernet. LLDP-MED TLVs are shown in
1.
LLDP-MED TLVs
1.
Type
LLDP-MED Capabilities
Network Policy
Extended Power-via-MDI
Hardware Revision
Firmware Revision
Software Revision
Serial Number
Manufacturer Name
Model Name
Asset ID
Location Identification
NOTE:
For more information about LLDPDU TLVs, see the IEEE standard (LLDP) 802.1AB-2005 and the LLDP-MED
standard (ANSI/TIA-1057).
Description
Contains the rate and duplex capabilities of the sending port, support
for auto negotiation, enabling status of auto negotiation, and the
current rate and duplex mode.
Contains Power supply capability of the port.
Indicates the support of the port for link aggregation, the aggregation
capability of the port, and the aggregation status (whether the link is in
an aggregation).
Indicates the supported maximum frame size. It is the MTU of the port.
Description
Allows a MED endpoint to advertise the supported LLDP-MED TLVs and its
device type.
Allows a network device or MED endpoint to advertise LAN type and VLAN ID
of the specific port, and the Layer 2 and Layer 3 priorities for a specific set of
applications.
Allows a network device or MED endpoint to advertise power-related
information (according to IEEE 802.3AF).
Allows a MED endpoint device to advertise its hardware version.
Allows a MED endpoint to advertise its firmware version.
Allows a MED endpoint to advertise its software version.
Allows an LLDP-MED endpoint device to advertise its serial number.
Allows a MED endpoint to advertise its vendor name.
Allows a MED endpoint to advertise its model name.
Allows a MED endpoint to advertise its asset ID. The typical case is that the
user specifies the asset ID for the endpoint to facilitate directory management
and asset tracking.
Allows a network device to advertise the appropriate location identifier
information for an endpoint to use in the context of location-based
applications.
221